Roof Leak Repair in Murray, Utah

Many roof leaks in Murray begin around chimneys, walls, roof valleys, and other joints. On a home built around 1978, these areas may have been repaired more than once. Sealant and flashing can fail before the shingles do. We inspect the shingles and the leaking area separately. If the shingles are still in good condition, the leak may only require a localized repair.

Median year built from the US Census American Community Survey; elevation from USGS.

The source of a roof leak may be several feet away from the ceiling stain. These are some of the problems we commonly find on Murray roofs:

• Chimney flashing: A chimney creates several joints where masonry, metal flashing, and shingles meet. If one of those joints opens or the flashing fails, water can enter around the chimney.
• Roof-to-wall joints: Water can enter where a roof meets an exterior wall if the flashing is missing, damaged, or installed incorrectly. The water may travel behind siding before a stain appears inside the home.
• Old sealant used instead of proper flashing: Sealant can deteriorate much sooner than metal flashing. If sealant was used where flashing should control the water, the area may begin leaking when the sealant cracks or separates.
• Loose roofing nails: A roofing nail can slowly work its way upward and lift a shingle. The exposed nail hole can allow water to enter the wooden roof deck.
• Roof-valley problems: A roof valley carries water from two roof slopes into one drainage path. A small opening or damaged section in the valley can therefore allow a large amount of water into the roof.
• Cracked vent-pipe seals: The rubber collar around a vent pipe can crack as it ages. Water can then enter around the pipe and travel into the attic or ceiling below.

We photograph the source of the leak before we provide a repair quote. When appropriate, we test the repaired area with water to confirm that the leak has stopped.

One roof leak on an older Murray home does not automatically mean the roof needs replacement. A single failed vent, joint, or section of flashing can often be repaired. Multiple unrelated leaks across an aging roof are more concerning because they may show that several parts of the roofing system are failing. We inspect the full roof before recommending replacement. Many Murray homes date to around 1978, so the age and condition of the existing roof are important parts of that decision.

Roof leak repair in Murray starts with finding the exact place where water is entering. After we identify the source, we repair or replace the failed component. That may include flashing, a vent seal, a roof valley, or an edge detail. We test the repaired area with water when appropriate to confirm that the leak has stopped.

• We prioritize active leaks when possible because continued water entry can cause additional damage.
• We point out wet insulation, stained wood, or other signs that water has already reached the attic or roof structure.
• We use roofing materials that are appropriate for the existing roof, and our repair work is backed by our 5-year workmanship warranty.
• If the ceiling stain is caused by attic condensation rather than rainwater, we explain that. The solution may involve ventilation or insulation instead of roofing work.
• We provide photographs of the source of the leak and the completed repair so you can see what was found and what was fixed.
• We provide a written price before repair work begins. The quote is based on the problem we identified during the inspection.

For the full picture of the service, see Roof Leak Repair.

Courtland Roofing finds roof leaks in Murray by tracing the path of the water back to its entry point. We do not assume that the leak started directly above the ceiling stain. We photograph the source before the repair. When conditions allow, we test the repaired area with water to confirm that it no longer leaks.

1. Start with what you have seen How long the stain has been there, whether it has grown, and what the weather was doing each time it appeared all matter. On a Murray roof that history rules out more possibilities in two minutes on the phone than an hour of walking the roof does.
2. Trace the water from insideThe ceiling stain may be several feet away from the actual roof opening. We inspect the attic and follow visible water marks back toward the point where water entered.
3. Confirm the source before repairing itIf the entry point is not obvious, we test small sections of the roof with water. We start low and work upward until we identify the area that allows water inside.
4. Repair the failed component and re-test itWe replace or rebuild the part that is allowing water in instead of relying on another layer of sealant. We then test the area again when conditions allow.

Courtland Roofing provides roof-leak repair in Murray. We are family-owned, licensed, insured, and manufacturer-certified. We inspect the roof and trace the water before recommending a repair. Identifying the correct entry point is important because repairing the wrong area will not stop the leak.

Certified installer for GAF, CertainTeed and Owens Corning, family-owned, licensed & insured.

Courtland Roofing has traced and fixed leaks in every part of Murray, Utah (84107, 84123, 84121 and 84117), including the streets around Murray Park and Fashion Place. We give homeowners across the rest of Salt Lake County the same service, including in Alta, Granite and Salt Lake City.

If you do not see your ZIP code listed, call or text us. We can confirm whether we provide roof-leak repair at your address in Murray.